New designs, old inspirations

Last weekend I went to Stratford-upon-Avon with one friend and one goblin (my fiancé), and it made me think about the Elizabethan obsession with pearls (of which more in a later blog post). I’ve created a new pendant inspired by the trip, and by the success of my other Tudor-inspired piece (which was actually based on a coin I got from Kentwell in Year 5). Enough brackets; I thought I’d give you all a behind-the-scenes look at the process of creating a new design from scratch.

IMG_20170409_180510561_HDR

I didn’t actually draw up a design for this one, so the process was a little messier than usual, but here’s the rough blueprint…

Start with some D-shaped sterling silver wire (this is 4mm x 1.4mm):

Cut it to size with a hand saw:

File the ends smooth:

Bend the filed wire into a teardrop shape, continuing to file and shape the ends to get a perfectly flush fit. This will make for a much more successful solder.

Once the ends are filed and bent flush together, saw through the seam. This removes the tiny gap between the ends and allows for a tighter seam and better solder. (No pictures, because it involves both hands and a lot of swearing.)

Have a bit of a soldering mishap, blacken and warp the teardrop, and give up for the day to embroider and write a blog post. After some sewing, napping and sulking, redo the above steps…

Once soldered with a hand torch, the teardrop shape goes into the pickle pot (a slow cooker full of water mixed with a chemical compound that removes the residue from the flux used when soldering).

After that, file down any visible edges of the seam.

Draw guide spots for drill holes with a pencil, like this one I got on my Stratford trip:

img_20170408_165432588.jpg

Drill through each side (I use The Goblin’s power drill with a 1cm bit):

Shape and cut a silver pin, then affix into a half-drilled pearl (half-drilled as in only one hole which reaches halfway through the pearl):

Cut some unfinished chain to the desired length (I went with a classic 18-inch):

Thread the chain and pearl through the holes drilled earlier. Later on, decide the pearl needs to hang lower and add a couple of jump rings (see later pictures)…

Solder fixings to each end of the chain:

And finally, back into the pickle pot! (Just the ends though – don’t want to have to re-polish everything.)

 

Et voilà! Tudor-inspired, minimalist pearl pendant, available now at Tiding of Magpies.

IMG_20170409_180249259~2

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s